...
- PIPE-1287 - fluxboot failing with target intent using pointing and a CG intent with the pointing setup
- PIPE-1335 - selection heuristics when delay calibrator mixed with CG intent
- PIPE-1098 - cont.dat failures for targets with some characters
Primary Development Priorities
Calibration and Flagging
Enhanced DTS issue identification and flagging (CASR-563/PIPE-986)
- Option to disable bad deformatter flagging completely or partially, (PIPE-1183)
Possible RFI flagging refinements
- per baseline flagging - (PIPE-1286)
- combine targetflag heuristics into checkflag - (PIPE-1342)
- flux calibrator RFI flagging should use residuals - (PIPE-1274)
- Backup flags in hifv_applycal prior to calibration (PIPE-854)
- Change hifv_targetflag to flag target data using a .flagtargetstemplate.txt - (PIPE-37)
- Add plots to statwt weblog in PI pipeline (PIPE-1341)
- Long solution interval calculation improvement (PIPE-1002/PIPEREQ-64)
- Short Solution interval calculation improvments (PIPE-1340)
Per-baseband delay solutions (PIPE-670)
Spectral window mapping for gain calibration (PIPE-671)
enables phase calibration if not enough S/N due to faint calibrator
Antenna position corrections in a post-observation time window (CASR-556)
Gain table flagging extensions
Ripple detection (bad switch problem) (PIPEREQ-11)
Gain outlier detection (PIPEREQ-10)
Fluxboot gain solution flagging (PIPEREQ-9)
Fluxboot QA metric adjustments (PIPEREQ-8)
...
- Enable self-calibration heuristics for continuum data only in new task (hif_selfcal) and operate on only the _cont.ms (PIPE-)
- Joint ALMA and VLA development and should work on both types of data
- SRDP heuristics team input
Spectral lines
Cont.dat interpretation to treat non-specified spws as continuum-only (PIPE-1043)Ability to use _line and cont.ms in different pipeline tasks.
Spectral line calibration recipe definition (PIPE-1344)
- Save pre-target RFI flagging and split non-RFI flagged data after hifv_statwt using a new task (PIPE-1343)
- For VLA data, enable steps to run findcont to only run on line spws
- hif_makeimlist(specmode='mfs')
- hif_findcont()
- hif_uvcontfit()
- hif_uvcontsub()
Spectral window mapping for gain calibration (PIPE-671)
enables phase calibration if not enough S/N on narrow spws
- Use MS tool hanning smoothing to enable per spw hanning smoothing (CASR-523; PIPE-672)
- Zoom-in plots on non-128 MHz windows for inspection of bandpass in finalcals?
- Cont.dat interpretation to treat non-specified spws as continuum-only (PIPE-1043)
Weblog
- Zoom feature for all hif_makeimages plots (PIPE-1083)
- plot labels in semifinalbpdcals (PIPE-984)
- parallactic angle vs time plot (PIPE-836)
- Add API plot to VLA pipeline runs (PIPE-580)
...