VLASS 2022 Priorities
- Cube Imaging pipeline PIPEREQ-142
VLA 2022 Priorities
Bugs
- PIPE-1287 - fluxboot failing with target intent using pointing and a CG intent with the pointing setup
- PIPE-1335 - selection heurisitcs heuristics when delay calibrator mixed with CG intent
...
Enhanced DTS issue identification and flagging (CASR-563)
Possible RFI flagging refinements
- per baseline flagging
- combine targetflag heuristics into checkflag
- flux calibrator RFI flagging should use residuals - PIPE-1274
- Change hifv_targetflag to flag target data using a .flagtargetstemplate.txt
- Add plots to PI pipeline statwt weblog
- Only show post statwt plots
- show box plots for weights per spw, per antenna, and per scan
- ID places where statwt goes sideways
- Long solution interval calculation improvement (PIPE-1002/PIPEREQ-64)
- Short solint calculation improvement
Per-baseband delay solutions (PIPE-670)
Spectral window mapping for gain calibration (PIPE-671)
enables phase calibration if not enough S/N due to faint calibrator
Antenna position corrections in a post-observation time window (CASR-556)
Gain table flagging extensions
Ripple detection (bad switch problem) (PIPEREQ-11)
Gain outlier detection (PIPEREQ-10)
Fluxboot gain solution flagging (PIPEREQ-9)
Fluxboot QA metric adjustments (PIPEREQ-8)
Enable data weights to be determined from switched power (CASR-476)
Use MS tool hanning smoothing to enable per spw hanning smoothing (CASR-523; PIPE-672)
Spectral window mapping for gain calibration (PIPE-671)
enables phase calibration if not enough S/N on narrow spws
...
- Generalize hifv_circfeedpolcal for all bands
Enable experimental P-band calibration
Enable pipeline to use two MS files to perform continuum on one and spectral line optimized calibration on the other when spectral lines are a science goal set in PST
Define requirements for the continuum imaging pipeline to use outlier fields to remove effects of bright sources rather than using large images
2021 Priorities
Primary Development Priorities
...