Page History

Checklist for SRDP calibrations of VLA data, based heavily on the VLASS one.

...

Checklist (in order of pipeline stage):

1. hifv_flagdata - online flags. Notify scientist if >20% flagged - maybe should be 35%?
2. hifv_priorcals - check for gain compression due to severe RFI - is hifv_syspower part of the regular pipeline yet? If not, probably need to flag.
3. hifv_testBDdcals - check for Data Transmission System (DTS) problems.
4. hifv_flagbaddef - check that any DTS issues have been flagged.
5. hifv_semiFinalBPdcals - check for any remaining DTS issues.
6. hifv_solint - check solints for calibrators are reasonable (< a few mins for the long interval, > ~0.1s for the short interval) - if in doubt check with a scientist.
7. hifv_fluxboot2:
   1. check the input tables look clean 
   2. check that  the model is reasonable and covers all spw.
   3. make a note of the phase calibrator flux densities.
      
8. hifv_finalcals:
   
   1. check for delay outliers
   2. check for unusual bandpass shapes
   3. check for outlying bandpass phases
   4. phase (short) gain solution: check for large phase scatter
   5. final amp/time: check for outliers
   6. final amp/freq: check that outliers fall into known bad spw
   7. Final phase - check there are no phase jumps > 90deg
9. hifv_applycals: check end of CASA log and note final % flagged. If over 50%? check with a scientist
10. hifv_plotsummary:
    1. phase vs time plots: check all are centered on zero
    2. amp vs uvwave:
       1. check calibrators are point-like (constant flux)
       2. check there is no evidence of decorrelation (strong "waterfall")
       3. check RFI is fully flagged
    3. amp vs frequency:
       
       1. check for residual RFI on calibrators
       2. check for residual RFI on targets
11. Rerun with additional flagging if needed.
12. Once satisfied, write a short overall evaluation suitable for transmission to the PI (no cuss words!)

...